Close the door, put the 2nd key in the door lock, turn the key to the unlock position and hold it untill you hear the alarm horn chirp, release the key. Press any button on the remote, you should hear a chirp from the alarm horn, press button on the 2nd remote, you will hear two chirps, 3rd remote will chirp 3 times, and the 4th remote will chirp 4 times, then lock the door with the key.
Unlock the door, remove the key from the ignition, close the door and try the remote. You can match any remote to any car. You teach the car to respond to each remote. With the dealers scan tool. Lock and unlock the doors with your key or use the key fob to do the same. Call the Oldsmobile car dealer. How do I check transmition fluid n 98 vw jetta vr6 2.
We had this problem with our '98 E and it turned out the battery in the valet key needed replacing. It seems like the grand marquis key-less entry model was the only model made where u would actually have to take to a dealership to have it program there as it requires a computer module to program it..
The speed sensor on a 98 Jetta is located near the brake setup. It is on the passenger wheel area mounted to a bracket. Fuse box on 98 Jetta is located under steering wheel above pedals. If it's anything like my 98 avenger. All you have to do is re lock the car with the key or if you have a key fob lock it that way.
It should disarm it once it goes off. I have a 98 jetta and I got a code How can I clear this code so my car will pass smog. Check the discussion page. Take it to a competent repair shop. I replaced the thermal sensor on mine I also have a 98 jetta didn't work. So it's either the fan switch or the control module fan relay. I purchased a new replacement key fob for the keyless entry because the original two that came with my car no longer work the buttons disinigrated.
I could still use my key in the door to unlock and lock my doors with the alarm working — just not with the key fob. I had even replaced the batteries with brand new ones. I took it into the service department for them to program the new key fob and they were not able to do so. They checked the signal from the key fob and said it was strong. When I got the car back the keyless entry would work sporadically; once every 8th time or so. My car just locks and unlocks — no alarm, no red light on the door.
Do you have the door open while you're trying to do this? That could be your entire problem right there. Unless, of course, you're saying your door lock has been unusable this entire time. Then you're hosed, and P2B had your answer.
Door should be closed, and the window open, so you can turn the key while doing the other turning and pushing, etc. Ok thx all, I'll try to open my door panel and connect the lock switch. And I'll make sure the door is close. Ok, my door panel is disassemble, and i've done the procedure. I hear the 3 bip, but when I push the lock or unlock button on my new key fob, nothing happen? Any suggestion? Last edited: Feb 14, You sure you have the right fob? Make sure the numbers match. Yeah, all the numbers match The battery is ok , everything seem fine Please specify what you did to try to program the two keys.
Step by step.
0コメント